141 Industrial Dr, Boerne, TX 78006
Available 24/7 · Mon–Sun
New faucets, toilets, and shower fixtures work best when the valves and connections behind them are ready. We install fixtures in Boerne homes with attention to fit, flow, and clean finishing.
Call (830) 390-1039 for fixture installation in Boerne when a faucet drips, a toilet runs all night, or a sink, shower valve, or laundry faucet needs to be set correctly.
A new faucet or toilet is only as good as the valve behind it. A plumber in Boerne should open the cabinet far enough to see the stop, and Boerne Pipe and Drain Pros installs and repairs kitchen and bath fixtures in Boerne and Bulverde, and our plumbers open the cabinet or the wall far enough to see what the new trim will actually connect to. Houses, townhomes, and condos get the same order of work.
On City of Boerne Utilities water, mineral scale shortens cartridge life and leaves crust at aerators and shower heads. That hardness talk applies to city customers. If your bill is from Texas Water Company or a well, tell us so we do not treat the fixtures as if they see the same water.
Follow the symptom to the service page that explains the work in more detail.
Each fixture has a slightly different failure, but the stops always come first.
Faucet installation includes new supplies and a working stop on each side. Repair is fair when the cartridge or the aerator is the only failure and the body is sound. We do not set a new faucet on a valve that already weeps in the cabinet.
A toilet that keeps running is often a flapper or a fill valve. A rock at the base, a stain that keeps returning, or a loose bowl can be a wax ring or a closet flange. We reset or replace the toilet on a sound flange, and we look past the closet if two baths act up together.
Sink installation includes the trap, the stops, and a level set. A shower valve that keeps passing water, or a shower that fades as scale builds in the cartridge, needs the valve opened, not just a new head. Tile stays closed until we know the valve body is still usable.
The pretty part is the last step, not the first.
We test every stop we will use. A seized or dripping angle stop is replaced before the new fixture is set. Braided supplies that are stained, kinked, or original to a much older faucet get replaced at the same time.
If a cabinet is already wet, pipe repair may be the real job. If several fixtures are weak at once, the trouble may be in the house supply, not in the trim. We will tell you that before we unpack a faucet box.
Related work includes garbage disposal repair, water heater repair when the hot side is the complaint, and plumbing services for the wider residential list. The FAQ and About pages explain how a visit is set up, and the Contact page is the phone path. If water is already spreading from a failed supply, call us at (830) 390-1039 and treat it as emergency plumbing.
Fixture prices in Boerne vary with the faucet or toilet you choose and with the condition of the shutoff, flange, or supply line behind it.
| Service | Typical cost in Boerne |
|---|---|
| Faucet repair | $125 to $300 |
| Faucet replacement | $150 to $400 |
| Toilet repair | $125 to $350 |
| Toilet installation | $250 to $700 |
| Shower valve or cartridge work | $200 to $600 |
These figures are typical ranges for Boerne and the Hill Country area, not a final bill. The final price depends on the problem, the parts, how hard the work is to reach, and whether the call is after hours. We diagnose on site and give you the number before any repair starts.
Compare these figures with the full list on our plumbing cost in Boerne page, or call (830) 390-1039.
Faucet installation typically runs $150 to $400 in Boerne, depending on the faucet type and whether the stops and supply lines also need replacing. Older homes in Esperanza and Champion Heights often need new stops at the same time, which affects the final price. We confirm the number on site before work starts.
If you want a filtered line run to a kitchen faucet, we can add that during installation while the supply lines are already open. Tell us in advance so we bring the right fittings. This is common in Boerne homes on well water or Texas Water Company service.
Homes with original galvanized or decades-old supply lines often have stops that are seized or corroded. We test each one before connecting new trim, and replace what will not hold. This is more common in older Boerne neighborhoods than in newer Cordillera Ranch construction.
Most single-fixture installations take under two hours once the plumber confirms the stops and supply lines are sound. Jobs take longer if a flange is broken, a stop is seized in the wall, or multiple fixtures are done in one visit.
Yes, when the stops and the supply lines are in reachable shape and the parts are on the truck or already on site. We test each stop before we pull the old fixture. If a valve twists in the wall, that repair comes before the new trim goes on.
Hard city water scales cartridges and aerators, and a tired stop can pass a trickle even after the handle is closed. We open the valve enough to see the condition of the cartridge and the supply, then we replace what actually failed. A pretty trim kit on a scaled valve will drip again.
We repair a running toilet when the flapper, the fill valve, or the seal under the bowl is the problem and the china is sound. Toilet installation is the path when the tank is cracked, the bowl is stained through, or the closet flange is broken.
No. A stop that has not moved in years can twist off in the wall if you force it. Leave it where it is and call us. We will isolate the fixture and replace the stop if it will not hold.
If a faucet is already dripping or a toilet will not stop running, call (830) 390-1039 now and a plumber will start at the stops, then at the fixture.
Service ZIPs: 78006, 78015, 78163
Call with the room, fixture, or outside area involved and tell us whether the water is still moving.
For leaks, drains, water heaters, fixtures, and buried lines, start with one direct call.